Create 3D in Photoshop

With a few simple steps, you can turn your ordinary photos into a 3D image red / cyan depth. Do you think that creating a 3D image using lenses as the image is seen on the internet is not difficult or complicated. If you think it's hard to see, after this article, you will have to think back a bit. Part 1: Effects 3D red / cyan simple   A 3D image is typically created by shooting the same object from two different points and then combining them. Of course with regular 2D images we can not do so, the same way as an interference with the channel of the image. Conditions need to be converted to 3D images in this way is that the image must be RGB color mode, when you open up an image in Photoshop, you can check or change the image's color mode to Image > Mode and select RGB (color mode if your image is not RGB). Start by duplicating your photos to about 2 times, then select the top layer, the Channel (tab next to layers), when the Channel, select the Red channel as shown. Press Ctrl + A to select all the frames. Note that in this step, your image black and white only, not to worry because the color of the picture completely changed just by selecting the images being shown the red zone only. Press V to select the Move Tool, move the image to the left a bit like this. But before making the move, you should make sure that the box Background color is black. Once completed, simply select the RGB channel and back layer tab, and this is the result. At this point you have completed the creation of 3D red / cyan for your photos, but need a few more steps to photograph real depth. Part 2: Add depth to the image Layer is selected remained in the above steps, this time you add a layer mask (Layer> Layer Mask> Reveal All). Press B select Brush Tool, reduction of Brush Hardness to 0, Foreground color is black. Our goal is to make the background areas of the image back to its original state by highlighting the area on a black layer mask to hide them. After completion of the background image of the photo goes, you select the layer below the layer containing the mask to continue to perform the following steps. Channel tab, you choose the Red channel, Ctrl + A to select all the frames and then press Ctrl + T to adjust the image, namely the Red channel will stretch this out horizontally. Select the RGB channel again, back to the Layers tab, and that you have finished making your pictures into a 3D image red / cyan. If there is a pair of glasses red / cyan, you can check your results immediately. Wish you success!